LT8311E--USB 2.0 中继器 USB 2.0 Repeater

1. 概述

LT8311E 是一款低成本高性能 USB 中继器，可通过 cat5/5e/6 电缆提供信号传输扩展，符合 USB2.0 规范（高达 480Mbps）。通过 CAT120 电缆，从 USB 集线器/主机的位置到最大扩展长度可达 6 米。LT8311E 消除了 USB5.2 规范的 0 米距离限制。
USB2.0中继器有两个不同的端口。一个端口用于通过 USB2.0 电缆连接到 USB 主机、集线器或设备，另一个端口用于通过 cat5/5e/6 电缆连接到另一个 USB 中继器。有四条线路用于在两个LT8311E芯片之间进行数据传输。图 3.1 显示了典型应用。内部均衡设置可以在可变介质条件下通过板载开关更改，例如，当使用不同长度的 cat5/5e/6 电缆时。

2. 特点

• 延伸长度可达120米
• 支持USB 2.0高速和USB 1.1（低速和全速）
• 支持热插拔• 内部上拉和下拉电阻
• 用于均衡的
I2C控制模式• 单3.3V电源
• 16引脚TSSOP RoHS封装
• -40至85°C工作温度范围

• 静电放电：HBM至2KV

3.应用

• 台式机和笔记本电脑、扩展坞
• 服务器和工作站
• 数据存储系统N

1. General Description

LT8311E is a low cost high performance USB repeater that provides signal transferring extension over cat5/5e/6 cable, compliant with USB2.0 specification (up to 480Mbps). The maximum extension length can be up to 120 meters from the location of USB hub/host over CAT6 cable. The LT8311E eliminates the 5 meters distance limitation of USB2.0 specification.
There are two different ports for USB2.0 repeater. One port is used for connecting to the USB host, hub or device by USB2.0 cable, the other is used for connecting to another USB repeater by cat5/5e/6 cable. There are four lines used for data transferring between two LT8311E chips. Figure 3.1 shows the typical application. Internal equalization settings can be changed by switch on board under variable media conditions, such as, when using different length of cat5/5e/6 cable.

2. Features

• Extension length up to 120 meters
• Support USB 2.0 high-speed and USB 1.1(low-speed and full-speed)
• Support hot plugg
• Internal pull-up and pull-down resistor
• I2C control mode for equalization
• Single 3.3V power supply
• 16-pin TSSOP  RoHS package
• -40 to 85℃ operating temperature range
• ESD:HBM to 2KV

3.Applications

• Desktop and laptop computers, docking stations
• Servers and workstations
• Data storage systems