LT8312–USB2.0 extender with switch，QFN20，4×4 DeMUX
USB2.0 Extender with DeMUX
LT84101D–双端口双向 USB3.1 Gen-1 Dual-Port Bi-directional USB3.1 Gen-1 Re-driver
1. Description LT84101D is a deeply-optimized USB re-driver IC that enhances signal quality by performing cable or board trace loss compensation under USB3.1 Gen-1 and USB2.0 specification respectively. For USB3.1 Gen-1operation, LT84101D is a dual-port bi-directional 5 Gb/s SuperSpeed (SS) re-driver device with advanced power management. It is composed of a dual-channel...
LT8311SX–带单差分对的 USB 2.0 扩展器 USB2.0 Extender with Integrated MCU
1. 概述 LT8311SX 是一款高性能 USB2.0 扩展器，可通过以太网电缆或标准 USB 电缆提供 USB 信号重复。LT2SX 符合 USB0.8311 规范，支持高速、全速和低速通信。它将USB2.0 HS传输距离扩展到60m，速度为480Mbps，因此消除了USB5.2规范的0m限制。此外，还支持用户定义的数据包，为边带数据通信提供路径。它专为长电缆应用而设计，因此非常适合扩展USB2.0 I/O设备（如USB2.0相机，硬盘驱动器，闪存驱动器，打印机，扫描仪等）的覆盖范围。系统控制也可通过配置 I2C 从接口实现。 2. 特点 • USB2.0扩展器• 其他 3.应用 • 监控• KVM 扩展 • 汽车系统 1. General Description The LT8311SX is a high performance USB2.0 extender which provides USB signal repeating over Ethernet cable or standard USB cable. Compliant with USB2.0 specification, the LT8311SX...
LT8311X3 —USB 2.0 High Speed Signal Repeater
1. General Description The LT8311X3 is a USB 2.0 high speed signal repeater, used to compensate high speed signal attenuation caused by ISI. Programmed compensation gain selected via external pull down resistor helps to improve USB 2.0 high speed signal quality and pass CTS tests. 2. Features • Compatible with USB 2.0, OTG 2.0...
LT8713SX —Type-C/DP1.4 to Tri-Port DP1.4/HDMI2.0Converter with Audio
LT8713SX 是一款高性能 Type-C/DP1.4 至 Type-C/DP1.4/HDMI2.0 转换器，具有三个可配置的 DP1.4/HDMI2.0/DP++ 输出接口和音频输出接口。LT8713SX同时支持显示端口™单流传输（SST）模式和多流传输（MST）模式。当接收通过单个DP链路打包和传输的多个视频/音频流时，LT8713SX将分组的多流恢复为多个不同的视频/音频流。在 SST 模式下，三个 TX 接口输出相同的视频流/音频流。此外，还包括三个用于CC通信的CC控制器，以实现DP Alt模式和供电功能，一个用于上游Type-C端口，一个用于下游端口，最后一个用于供电。片上USB3.0开关是一种高速双向无源开关，提供灵活的开关以适应连接器翻转。 提供两个数字音频输入或输出接口，包括 I2S 和 SPDIF。两者都支持最大 8KHz 采样率的 192 通道 LPCM 或压缩音频。 该器件能够自动操作，由集成微处理器启用，该微处理器使用嵌入式SPI闪存进行固件存储。系统控制也可以通过使用专用的配置 I2C 从接口来实现。 The LT8713SX is a high performance Type-C/DP1.4 to Type-C/DP1.4/HDMI2.0 converter, with three configurable DP1.4/HDMI2.0/DP++ output interfaces and audio output interface. LT8713SX supports both the DisplayPort™ Single Stream...
LT8400C — e-Marker Chip for USB Type-C Cable (EMCA)
1. Description LT8400C is a deeply-optimized e-Marker IC for both passive and active full featured USB Type-C cable (EMCA). It supports SOP, SOP’/SOP” communication, providing a scheme to interact between source and cable (port-to-cable).LT8400C internally integrates an 8-bit OCM and flash memory (stacked die) to configure and run program. Online software...